[PlanetCCRMA] M-Audio Delta 1010 LT

[Roy Vestal]

I don't know about the Delta 1010LT so I can't help you with the jumper 
settings. I have the rackmount Delta 1010.

I'm not in front of my audio workstation atm (day job) :~(
What I do for EnvyControl24, I go to the 3rd tab (Patchbay i think) and 
change the output from PCM to the channel of the output.

I have an older EV 1642 sound board that has direct in/outs on each 
channel. I use a TRS to stereo cable so my returns are on the same 
channel as my sends. In my case, I simply change the PCM setting to the 
channel hardware setting. You can then go to the 1st tab (again, I don't 
remember the exact name) and link the stereo controls (Link tab at the 
bottom) and control mute and output there, just as if it were hardware. 
I also have a BCF2000 midi control surface, so I can assign the channel 
to a slider if needed.

HTH

pyrael wrote:
>
> kelly-9 wrote:
>   
>> don't forget about the jumpers on the board that set the atenuation on the 
>> balanced ins. you don't want to blow out the pres on these. but yea, going 
>> since fc3 with this board and a mackie mixer. haven't had a glitch in a 
>> long while. for real time csound you can get some short buffers and 
>> ardour/jack work fine here.
>>
>> k.
>>
>>     
>
> I was told but a guy at another forum about those jumpers. He said he
> disables the pres (jumper?) and uses external pres. I'd assume there is more
> to it than just not wanting to blow them, I'd assume he uses externals for
> better sound or something. good to know, thanks for the info
>
> Pyrael
>
>