[PlanetCCRMA] Delta 1010LT SPDIF Volume Control?
Rick Sutphin
sutphinc at bellsouth.net
Tue May 24 15:59:01 PDT 2005
Frank smith wrote:
>Hi
>I to have the same problem ( now I've got the right Kernel running!)
>
>I can see input from my DDX3216 into my M-audio 2496 audiophile, but I
>cant seem to get any output to the desk at all.
>
>In envy24control the spdiff in is showing input, but the output (spdiff
>out l+r) is showing very low output.
>
>I'm on FC3 + planet
>cheers
>Bob
>
>
>
>
>On Tue, 2005-05-24 at 07:04 -0400, Rick Sutphin wrote:
>
>
>>John,
>>
>>Thanks for the answer. After a little experimentation, I am starting
>>to
>>think the problem is not with the Delta 1010LT, but with the settings
>>on
>>my mixing board which is receiving the S/PDIF signal.
>>
>>Rick
>>
>>
>
>
>_______________________________________________
>PlanetCCRMA mailing list
>PlanetCCRMA at ccrma.stanford.edu
>http://ccrma-mail.stanford.edu/mailman/listinfo/planetccrma
>
>
>
Hi Frank,
I am beginning thinking that the problem is with the DDX3216. I started
Hydrogen, and set its outputs to S/PDIF Out. I then enable the digital
mixer on PCM_1 and PCM_2, which are connected to channels 1 & 2 of the
DDX3216. With this configuration, I get output on PCM_1 and PCM_2. I too
am also seeing output on SPDIF Out, but I am getting good signal levels.
Unfortunately, there is not much documentation regarding S/PDIF in the
DDX3216 manual (just the 3 settings on the S/PDIF I/O page).
I am having a hard time coming up with ideas to trouble-shoot this
problem in a systematic way. If I stumble accross a solution, I'll let
you know.
Rick
More information about the PlanetCCRMA
mailing list