[PlanetCCRMA] No sound configuring RHC3

[John S. Dey]

Hi,

I just installed RHC3 and updated software and sound programs.  aplay 
does not not result in any sound.  I did run alsamixer and turned 
volume up.

The follow data might provide you with an idea of what I have missed.  
Any comments or suggestions would be greatly appreciated.  Thanks

John

[root at jsdey etc]# uname -r
2.6.10-2.1.ll.rhfc3.ccrma
Sound plays using the following test:
Application->System Settings->Soundcard Detection


-- modprobe.conf

alias eth0 8139too
alias snd-card-0 snd-emu10k1
options snd-card-0 index=0
install snd-emu10k1 /sbin/modprobe --ignore-install snd-emu10k1 && 
/usr/sbin/alsactl restore >/dev/null 2>&1 || :
remove snd-emu10k1 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; }; 
/sbin/modprobe -r --ignore-remove snd-emu10k1
alias usb-controller ehci-hcd
alias usb-controller1 uhci-hcd
# --- BEGIN: Generated by ALSACONF, do not edit. ---
# --- ALSACONF verion 1.0.8 ---
alias snd-card-0 snd-emu10k1
alias sound-slot-0 snd-emu10k1
# --- END: Generated by ALSACONF, do not edit. ---

[root at jsdey robo6]# /etc/rc.d/init.d/alsasound restart
Shutting down sound driver                                 [  OK  ]
Starting sound driver snd-emu10k1                          [  OK  ]
Starting sound driver snd-emu10k1                          [  OK  ]
Starting sequencer                                         [  OK  ]
Starting sequencer driver snd-emu10k1-synth                [  OK  ]
Starting sequencer driver snd-seq-midi                     [  OK  ]
Restoring sound driver settings /usr/sbin/alsactl: load_state:1267: No 
soundcards found...
                                                            [FAILED]
Whoops!!!!

[robo6 at jsdey ~]$ aplay -device="plughw" 01-Overture.wav
Playing WAVE '01-Overture.wav' : Signed 16 bit Little Endian, Rate 
44100 Hz, Stereo
Aborted by signal Interrupt...