[PlanetCCRMA] Re: [linux-audio-dev] HDSP 9652 Users - Request for info

D R Holsbeck drh@niptron.com
Tue Dec 10 11:38:01 2002

have you tried doing it manually? 

modprobe -v snd-hammerfall-mem 
modprobe -v snd-hdsp 

what happens? Make sure you load the snd-hammerfall-mem modules before
any other module. 

also you will have to set the output levels on the channels. If you run
the command "amixer contents" you should see something like 

  ; type=INTEGER,access=rw---,values=1,min=0,max=65536,step=1
  : values=0

one for each of the 26 channels, index=(1-25). You can set the volume
with the following script


for i in $(seq 1 26);do
amixer -c 0 sset 'Chn',$i 85%

if all this goes well you should be ready to go. If you dont get any
output, but everything works ok, try setting up the card, then do a warm
reboot (ctl-alt-delete) and set it up again.

On Tue, 2002-12-10 at 12:18, Mark Knecht wrote: 
> Hi,
>    I would like to request that if there are any users of the new RME HDSP
> 9652 card that are able to successfully install and use this card, would you
> please get in touch with me and let me know what your system configurations
> are? I understand that there are at least a couple of you out there
> somewhere. Please let me know what distribution, kernel, C compiler, Alsa
> revision and anything else you think might be important.
>    Using the PlanetCCRMA flow I am unable to get this card configured and
> running. We believe that we have patched the Alsa layer correctly to add the
> 0x64 check but I am still unsuccessful. 
>    Thanks in advance.
> With best regards,
> Mark

Did you know that if you took all the economists in the world and lined
them up end to end, they'd still point in the wrong direction?