<div dir="ltr">Single pole IIR filters can easily be adjusted to a new sampling rate while preserving frequency response since the coefficient includes the sampling rate as part of its formula.<div><br></div><div>However, in sound effects use (my experience anyway) all pass filters are used for phase shifter (e.g. Pink Floyd) and as a component in most reverbs.  These structures tend to be more ad-hoc in their design intention - by which I mean that after a bit of experience, most people would know what to expect from an 800 Hz low pass vs. a 2.5 kHz low pass, but as far as what to expect from these other things, I think mostly we just wing it and see what happens.</div><div><br></div><div>All-pass tuning (frequency of max phase shift) is related to the length of the all-pass delay, and for delays longer than one sample, this shift is mirrored and copied throughout the spectrum.  So I can adjust the all-pass delay sample length proportionally with the ratio of new/old sample rate and it should preserve the delay time.</div><div><br></div><div>Next question is about the all-pass coefficient.  Generally I think &quot;how often does the signal go through the coefficient&quot;?  If you adjust the delay length to equalize the time, then my gut feeling is to keep the all-pass coefficients the same regardless of sampling rate.</div><div><br></div><div>However that is simply a wild guess, so thought I&#39;d check in the the DSP gods.</div><div><br></div><div>Thanks,</div><div><br></div><div>GW</div><div><br></div></div>