[PlanetCCRMA] No sound configuring RHC3

[Bradley S. Campbell]

John,

Try raising all the volume levels (i.e. pcm, pcm2, igain, line, cdrom, 
etc -- I up everything except the phone lines), and try soundcard 
detection (unless this is what you meant originally).

Brad

John S. Dey wrote:

> Brad,
>
> I ran aumix and increased vol and spkr to mid-range and verified that 
> the values were saved.  Still no sound from aplay.
>
> On Mar 17, 2005, at 4:03 PM, Bradley S. Campbell wrote:
>
>> John,
>>
>> Have you tried running aumix as root?  You may notice that all the 
>> levels are turned down.  I have FC3 and getting sound to work on it 
>> doesn't seem to be a trivial undertaking.  Best of luck!
>>
>> Brad
>>
>>
>> John S. Dey wrote:
>>
>>> Hi,
>>>
>>> I just installed RHC3 and updated software and sound programs.  
>>> aplay does not not result in any sound.  I did run alsamixer and 
>>> turned volume up.
>>>
>>> The follow data might provide you with an idea of what I have 
>>> missed.  Any comments or suggestions would be greatly appreciated.  
>>> Thanks
>>>
>>> John
>>>
>>> [root@jsdey etc]# uname -r
>>> 2.6.10-2.1.ll.rhfc3.ccrma
>>> Sound plays using the following test:
>>> Application->System Settings->Soundcard Detection
>>>
>>>
>>> -- modprobe.conf
>>>
>>> alias eth0 8139too
>>> alias snd-card-0 snd-emu10k1
>>> options snd-card-0 index=0
>>> install snd-emu10k1 /sbin/modprobe --ignore-install snd-emu10k1 && 
>>> /usr/sbin/alsactl restore >/dev/null 2>&1 || :
>>> remove snd-emu10k1 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; 
>>> }; /sbin/modprobe -r --ignore-remove snd-emu10k1
>>> alias usb-controller ehci-hcd
>>> alias usb-controller1 uhci-hcd
>>> # --- BEGIN: Generated by ALSACONF, do not edit. ---
>>> # --- ALSACONF verion 1.0.8 ---
>>> alias snd-card-0 snd-emu10k1
>>> alias sound-slot-0 snd-emu10k1
>>> # --- END: Generated by ALSACONF, do not edit. ---
>>>
>>> [root@jsdey robo6]# /etc/rc.d/init.d/alsasound restart
>>> Shutting down sound driver                                 [  OK  ]
>>> Starting sound driver snd-emu10k1                          [  OK  ]
>>> Starting sound driver snd-emu10k1                          [  OK  ]
>>> Starting sequencer                                         [  OK  ]
>>> Starting sequencer driver snd-emu10k1-synth                [  OK  ]
>>> Starting sequencer driver snd-seq-midi                     [  OK  ]
>>> Restoring sound driver settings /usr/sbin/alsactl: load_state:1267: 
>>> No soundcards found...
>>>                                                            [FAILED]
>>> Whoops!!!!
>>>
>>> [robo6@jsdey ~]$ aplay -device="plughw" 01-Overture.wav
>>> Playing WAVE '01-Overture.wav' : Signed 16 bit Little Endian, Rate 
>>> 44100 Hz, Stereo
>>> Aborted by signal Interrupt...
>>>
>>> _______________________________________________
>>> PlanetCCRMA mailing list
>>> PlanetCCRMA@ccrma.stanford.edu
>>> http://ccrma-mail.stanford.edu/mailman/listinfo/planetccrma
>>
>>
>>
>> _______________________________________________
>> PlanetCCRMA mailing list
>> PlanetCCRMA@ccrma.stanford.edu
>> http://ccrma-mail.stanford.edu/mailman/listinfo/planetccrma
>>
>
> _______________________________________________
> PlanetCCRMA mailing list
> PlanetCCRMA@ccrma.stanford.edu
> http://ccrma-mail.stanford.edu/mailman/listinfo/planetccrma